IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
Simultaneous use is possible.
When the USB tethering function is used to connect an Android smartphone while a smartphone is connected via Wi-Fi to the ILME-FX6 operating in Wi-Fi AP Mode, the following message may be displayed:
The IP address of the Wireless LAN Access Point Mode has been changed due to an IP address conflict.
If this message appears, communication between the smartphone connected via Wi-Fi AP Mode and the ILME-FX6 may have been disconnected.
If a message indicating that you have been disconnected is displayed on the Content Browser Mobile application screen or the remote control monitoring function does not operate properly, reestablish the Wi-Fi connection with the ILME-FX6, such as by turning the Wi-Fi function Off and then On again on the smartphone.